WSK-8 Water Soluble Matting Powder Kit           Used your browser button to go back

      

How to use FuseFX WS-Series Matting Powders...

FuseFX WS-Series Matting Powder is a unique blend of water base matting agents designed to eliminate the shine off of silicone painted surfaces, giving it a flat matt finish with little to no sheen.

FuseFX WS-Series Matting Powders must be used with M/F-110 Clear and both should be catalysed together for best results.
 
FuseFX WS-Series Matting Powders contains NO Amorphous Silica and NO Cabosil.

Please use an appropriate dust mask when using this product.

How to use:
After completing the final coat, touch-ups or airbrushed painting, apply a thin coat of
M/F-110 Clear and let cure or force dry with a hair dryer.

Apply a second coat of M/F-110 Clear, this time very lightly, just enough to “wet” the surface. Go over the surface with a “dry” brush to pick up any extra blobs of paint making the surface even. The surface must be just moist otherwise it will leave little specks of white powder. In this case you can touch it up the white spots by carefully scrapping off or touching up with a little color.

While the M/F-110 Clear is still wet, loosely apply the FuseFX Matting Powder by sprinkling or using a dry “fluff” brush stippling the surface as you go, do not rub.
A small Make-up Artist “Blush Brush” works great.
You don’t have to apply lots of powder just a little stippling to cover the surface, a little goes a long way.

Once the surface is fully covered, use a hair dryer to force catalysed the Clear and Powder together for MINIMUM of 3 to 5 minutes or let cure for about 3 hours.
You may also place the powdered piece IN A WARM OVER ONLY. Too hot may cause the powder to crystallize, creating an uneven surface.

Once cured, you can wash the prosthesis under warm to hot water and a little soap, pat dry and the surface is now ready.

If you missed any spots, simply apply a thin coat of M/F-110 Clear to the shiny areas and add a little FuseFX Matting Powder. Again, use a hair dryer to force catalyzed the Clear and Powder together for MINIMUM of 3 to 5 minutes.
Once cured, you can wash the prosthesis under warm to hot water and a little soap and pat dry.

If you find that the surface is too matt, you can always add a little sheen back to your already matt surface by stippling a light thin coat of M/F-110 Clear.